ZONE
0
Inside the bath or
shower. Must be
SELV (12V max) due
to water submersion.
225cm above the
bath or shower.
1
The area stretching
to 60cm outside the
bath or shower and
60cm from water
outlet of sink.
2
Technical drawings are for illustration purposes only.
Make sure you check all hole cut outs before work commences.
INSTALLATION
Lift the cabinet from the packaging
and position on a soft flat surface to
avoid scratching the mirror.
The mirror must be installed with
a minimum clearance of 150mm
between the infrared sensor and any
adjacent countertop or obstruction
to ensure correct function of the
sensor.
Mark a desired height of the
cabinet and draw a horizontal line on
the wall which corresponds with the
height of the cabinet hangers. Drill
the required holes and insert the wall
plugs using a stud detector to ensure
you avoid any wiring or water pipes.
The wall plugs supplied are only
suitable for solid stone/brick walls.
Screw the brackets to the wall using
the screws provided. Please ensure
they are fully tight.
1
Outside Zones.
Anywhere outside zones
0, 1 & 2. Where water jets
are not used for cleaning
purposes, the general
rules of BS7671 apply.
This mirror is IP44 rated
therefore suitable for
installation in zone 2 and
the outside zones.
Make sure to turn off the electrical
supply at the mains, then connection
must be made in accordance with the
latest IEE regulations. This cabinet is
manufactured to Class I and requires
an earth connection.
Hang the cabinet on the wall bracket.
The claws on the cabinet hangers
must be securely located on the
wall brackets. Use a spirit level to
adjust the angle of the cabinet by
turning screw A with a cross head
screwdriver.
When the angle is properly adjusted,
tighten screw B on both hangers.
Then secure the base of the cabinet
to the wall with the screw and
over-cap.
Close and secure the internal top
electrical cover with the small screws
removed earlier and switch on the
electrical supply at the mains to test
the function of the lamp and the
shaver socket.
Insert the shelf supports in the
desired positions starting with the
top shelf. Insert the glass shelves
and please make sure to tighten
the plastic screw at the bottom of
the shelf support to prevent the
shelves becoming loose. Rubber
plugs provided can be used to cover
unused shelf holes.
If the doors are out of alignment,
please first remove the soft-close
buffer (from bottom hinges), then
adjust the screws A, B and C on
hinges for 3 directional adjustment,
see diagram.
3
2
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the
crossed out wheelie bin symbol, indicates that this product may not be treated
as household waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic waste.
