General advice
Once the T-nut is in the groove and the component is
in place, the screw can be tightened. To create the
desired clamping, the T-nut must be turned 90° as
shown in the picture.
It may happen that the T-nut does not turn in the
groove when the screw gets tightened. If this
happens, you have to turn the screw back a little (do
not turn the screw all the way out because then you
will lose the nut!) and then tighten it again until the
T-nut produces the desired clamping.
In general, screws in plastic components should not
be tightened too much, otherwise they can break (as
soon as you hear noises, do not continue turning).
