V_97971.01
18
Filament insertion
Choose a spool size you want to use.
1 kg and smaller rolls are supported inside the machine dimensions, for up to 2.2 kg spools the
spoolholder and filament runout sensor can be mounted on the outside by rotating and remounting
them:
Insert the end of the filament into the filament runout sensor.
Make sure that the diameter of the tip of the filament is ≤ 1.75 mm.
Push the filament into the bowden tube until you notice resistance.
Now pull the lever on the printhead to the front:
Push the filament further.
When releasing the lever, the filament must be grabbed by the gear of the extruder.
Heat up the nozzle (see software instructions).
Extrude 50 mm of filament slowly (< 5 mm/s) via touchscreen or web interface.
To remove filament, perform the steps in opposite order. Start with heating the nozzle to the melting
point of your material.
