IEP Spidy ROLLER 12/24 V, Руководство по эксплуатации

Страница: 21 / 28

7 OPERATING INSTRUCTIONS Spidy Cable Reel
21
7.1.2 Checking and Replacing Ca-
bles
1. Dismount the cable reel (see also
Chapter 6.1.1 D
ISMOUNTING THE
C
ABLE
R
EEL
).
2. Screw off the cover as described in
Chapter 4.3.1 C
ONNECTING A
S
PIDY
ROLLER 12 V / 24 V (
WITHOUT COM-
PRESSED AIR SUPPLY
)
TO THE BATTERY TEST-
ING AND CHARGING SYSTEM
.
Note!
Turn off the compressed air
supply and, depending on the
device type, disconnect the air
hose.
3. Loosen the wires from the lustre ter-
minal (see also Chapter 4.3 C
ONNECT-
ING THE CABLE REEL
).
4. Loosen the screws and remove the
casing half.
5. Turn the spool with the cable the
opposite way to the pull out direction
until cable pre-tension is relieved and
the cable is no longer under tension.
6. Pull the slip ring off the axis.
7. Loosen the screws and carefully take
the bottom slip ring half out of the
spool.
8. Loosen the cable from the lustre ter-
minal of the bottom slip ring half.
Note!
Take note of the correct se-
quence so that you will be able
to reconnect the wires later (see
step 12).
9. Loosen the screws of the strain relief.
10. Remove the defective cable and the
cable stopper.
11. Push the new cable with its end
sleeves and cable stoppers through the
entry hole and tighten the strain relief.
12. Connect the wires in the correct order
to the lustre terminal of the bottom
slip ring half.
13. Push the bottom slip ring half onto the
spool's axis sleeve.
Note!
Make sure that the wires are
lying next to one another so
that the contact paths can
move freely.
14. Tighten the screws of the bottom slip
ring half and press each individual
contact to check its spring effect.
15. Wind the cable onto the spool without
turning the spool and pre-tension the