IEMCA VIP 80, Руководство по эксплуатации и техническому обслуживанию

Страница: 117 / 152

55
302.061
3
SETUP INFORMATION
3.1. PROTECTED PARAMETERS FOR SETTING-UP - Description
Foreword
These parameters affect the bar feeder configuration and the bar feeder-lathe inter-
face. Entering or modifying the value of such parameters is mainly required during
the installation of the bar feeder, performed by an authorised technician.
CAUTION: Each parameter has a specific default value (preset value). If the
operator does not change these values, the bar feeder performs the automatic
cycle according to them
INFORMATION: It is possible to enter or modify these parameter values only in
the appropriate data entering mode.
To enter this mode, the procedure described in section 4.1.1 must be followed.
This section’s pages are only destined to authorised technicians and might not be
attached to this manual. It is the exclusive right of the manufacturer to distribute
the information included herein.
During daily bar feeder utilization these parameters must not be modified.
The protected set-up parameters are made up of four sections:
•
Bar feeder phase parameters (paragraph 3.1.1);
•
Reference value parameters (paragraph 3.1.2);
•
Axis function parameters (paragraph 3.1.3);
•
Interface parameters (paragraph 3.1.4).
•
Parameters for generics (paragraph 3.1.5);