IEI Technology WAFER-KBN-1, Руководство пользователя

Страница: 73 / 138

WAFER-KBN-i1 3.5" SBC
Page 59
4.7 System Configuration
The system configuration is controlled by buttons, jumpers and switches. The system
configuration should be performed before installation.
4.7.1 AT/ATX Power Mode Selection
The AT and ATX power mode selection is made through the AT/ATX power mode switch
which is shown in Figure 4-12 .
Figure 4-12: AT/ATX Power Mode Switch Location
Setting Description
1-2 ATX power mode (default)
2-3 AT power mode
Table 4-1: AT/ATX Power Mode Switch Settings
4.7.2 Clear CMOS Button
To reset the BIOS, remove the on-board battery and press the clear CMOS button for
three seconds or more. The clear CMOS button location is shown in Figure 4-13 .
Figure 4-13: Clear CMOS Button Location