IEI Technology Wafer-8522, Руководство пользователя

Страница: 85 / 178

WAFER-8522 Motherboard
Figure 5-5: CF Card Setup Jumper Location
5.4.2 Clear CMOS Jumper
Jumper Label: JP2
Jumper Type: 2-pin header
Jumper Settings: See Table 5-3
Jumper Location: See Figure 5-6
If the WAFER-8522 fails to boot due to improper BIOS settings, the CMOS can be cleared
using the battery connector. Disconnect the battery from the connector for a few seconds
then reconnect the battery. The CMOS should be cleared.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-3 .
Clear CMOS Description
Open Keep CMOS Setup Default
Short Clear CMOS Setup
Table 5-3: JP2 Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 5-6 below.
Page 71
StockCheck.com