IEI Technology TANK-610-BW, Руководство пользователя

Страница: 24 / 98

TANK-610-BW Em b e d d e d S ys te m
P a g e 14

Qualified Personnel : The TANK-610-BW must be installed and operated
only by trained and qualified personnel. Maintenance, upgrades, or repairs
may only be carried out by qualified personnel who are familiar with the
associated dangers.

Air Circulation : Make sure there is sufficient air circulation when installing the
TANK-610-BW. The TANK-610-BW’s cooling vents must not be obstructed by
any objects. Blocking the vents can cause overheating of the TANK-610-BW.
Leave at least 5 cm of clearance around the TANK-610-BW to prevent
overheating.

Grounding : The TANK-610-BW should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the TANK-610-BW.
3.3 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1:
Remove seven retention screws from the bottom panel, as shown in Figure 3-1 .
Figure 3-1: Remove Retention Screws (Bottom Panel)
S te p 2:
Remove the bottom cover from the device. ( Figure 3-2 )