IEI Technology ROCKY-4786EV, Руководство пользователя

Страница: 65 / 145

ROCKY-4786EV/EVG User Manual
Page 55
4.4.1 CF Card Setup
Jumper Label: JP1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-2
Jumper Location:
See Figure 4-3
The CompactFlash® slot is connected through an IDE connection. This jumper sets the
CompactFlash® card as the master or slave IDE device.
Setting Description
Open Slave
Closed Master
Table 4-2: CompactFlash® Setup Jumper Settings
4.4.2 Reset CMOS Jumper
Jumper Label: JP2
Jumper Type: 3 pin header
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4-3
If the CPU Card fails to boot due to improper BIOS setting, use this jumper to clear the
CMOS data and reset the system BIOS information. To do this, use the jumper cap to
close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.
If the “CMOS Settings Wrong” message displays during the boot up process, you may
then try to correct the fault by pressing the F1 to enter the CMOS Setup menu. You may
then do one of the following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
StockCheck.com