RACK-360 QIG IEI Integration Corp. Page 4
STEP 4: INSTALL THE POWER SUPPLY UNIT (PSU)
Once the top cover and hold-down clamp have been removed, a user supplied PSU must be installed. Compatible IEI PSUs are listed in the
table below.
Model No.
Input
Type
Watt
Output Range
+3.3V
+5V
+12V1 +12V2
-5V
-12V
+5Vsb
ACE-935AL-RS
AC
AT
300W
N/A
40A
8A
N/A
0.3A
0.7A
N/A
ACE-A130C-R10
AC
ATX
300W
19A
16A
17A
17A
0.1A
0.5A
3A
ACE-R4130AP-RS
AC
ATX
300W
18A
25A
16A
N/A
0.5A
0.5A
2A
Table 2: Compatible IEI PSUs
The PSU is installed at the rear of the chassis and secured to the
chassis with six retention screws. To install the PSU, please follow
the steps below.
Step 1:
Correctly position the PSU at the rear of the chassis.
Make sure the power switch and the cable socket both
face outwards.
Step 2:
Once the PSU has been correctly positioned, secure the
PSU to the chassis by inserting two retention screws
through the side, and four retention screws through the
rear of the chassis.
Step 0:
Figure 6: Insert PSU Retention Screws
STEP 5: BACKPLANE INSTALLATION
The IEI backplanes listed below are compatible with the RACK-360
chassis.
Model No.
SBC Type
PCI
ISA
PSU Type
PCI-13SD-RS
PCIMG 1.0
3+4
3+3
AT/ATX
PCI-14S2-RS
PCIMG 1.0
4
8
AT/ATX
PCI-14S3-RS
PCIMG 1.0
4
9
AT/ATX
PX-14S3-RS
PCIMG 1.0
12
2
AT/ATX
PX-14S5-RS
PCIMG 1.0
7
5
AT/ATX
PE-6S
PICMG 1.3
2
0
ATX
PE-10S
PICMG 1.3
4
0
ATX
PE-10S2
PICMG 1.3
4
0
ATX
PXE-12S
PICMG 1.3
4
0
ATX
PXE-13S
PICMG 1.3
8
0
ATX
Table 3: Compatible IEI Backplanes
To install the backplane please follow the instructions below.
Step 1:
Insert the nine copper pillars in the predrilled screw holes
in the base of the chassis.
Figure 7: Copper Pillars Locations
Step 2:
Mount the backplane onto the copper pillars and align
the backplane mounting holes with the nine screw holes
in the copper pillars.
Step 3:
Once the backplane is properly aligned with the retention
screw holes, insert nine retention screws to secure the
backplane to the chassis.
Step 0:
STEP 6: CPU CARD INSTALLATION
To install the CPU card please follow the instructions below.
Step 1:
Remove the slot cover at the back of the chassis. To do
this, remove the slot cover retention screw at the top of
the slot cover. (See