IEI Technology PUZZLE-IN002, Руководство пользователя

Страница: 37 / 96

PUZZLE-IN002
Page 27
3.10 Mounting the System
The PUZZLE-IN002 is shipped with two mounting brackets that support 1U rack mount.
To install the mounting brackets, please follow the steps below.
Step 1:
Align the three retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the PUZZLE-IN002.
Step 2: Secure the brackets to the system by inserting three retention screws (M4*6)
into each bracket ( Figure 3-13 ). Make sure the screws are tight and on the right
positions.
Figure 3-13: Rack Mounting Bracket Installation
3.11 Power-On Procedure
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power-on the PUZZLE-IN002 please follow the steps below:
Step 1:
Connect the power source to the power inlet on the rear panel.
Step 2: Turn on the power switch to power up the system.
Step 3: The power LED indicator on the front panel turns to green.