52
Appendix D.
How to use Wake-Up Function
The NOVA-7800 provides two kinds of Wake up Function. This
page describes how to use Modem Wake-Up and LAN Wake-Up
function. Wake-Up function functions when you use ATX power
supply.
Wake-Up By Ring
:
You must set the option
Power On By Ring
of CMOS SETUP to
be enabled. The ATX power supply will be switched on when
there is a ring signal detected on pin “RI” of serial port.
Wake-Up On LAN
:
When your computer is in power-down status, you can see LAN
Link/Active LED is flashing. This status indicates that the LAN
chip has entered standby mode and waits for Wake-Up signal.
You can use other computers to wake up your computer by
sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a
factory, set ID, which you can find it from network information
in WINDOWS.
ID’s format is xxxxxxxxxxxx
Example ID
: 009027388320
