IEI Technology KINO-QM770, Руководство пользователя

Страница: 77 / 208

KINO-QM770 Mini-ITX SBC
Page 61
Step 2: Align the SO-DIMM with the socket . Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-6 .
Step 3: Insert the SO-DIMM . Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-6 .
Step 4: Removing a SO-DIMM . To remove a SO-DIMM, push both handles outward.
The memory module is ejected by a mechanism in the socket. Step 0:
4.5 PCIe Mini Card Installation
A PCIe Mini card slot is located on the solder side of the KINO-QM770. To install the PCIe
Mini card, please refer to the diagram and instructions below.
Figure 4-7: PCIe Mini Card Installation
Step 1: Insert into the socket at an angle . Line up the notch on the card with the notch
on the connector. Slide the PCIe Mini card into the socket at an angle of about
20º.
Step 2: Push down until the card clips into place . Push the other end of the card
down until it clips into place on the plastic connector. Step 0: