IEI Technology KINO-AQ670, Руководство пользователя, Страница: 61 / 197

KINO-AQ670
P a g e 47
4.4 J u m p e r S e ttin g s
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 4-8: Jumper Locations
Before the KINO-AQ670 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-AQ670 are listed in Table 4-1 .
Description Type Label
AT/ATX mode select 2-pin header JATX_AT1
Clear CMOS 3-pin header J_CMOS2
WOL Mode select 3-pin header WOL_SEL1
Table 4-1: Jumpers
4.4.1 AT/ATX Mo d e S e le c t J u m p e r
J u m p e r La b e l:
JATX_AT1
J u m p e r Typ e :
2-pin header
J u m p e r S e ttin g s :
See Table 4-2
J u m p e r Lo c a tio n :
See Figure 4-9
The AT/ATX mode select jumper specifies the systems power mode as AT or ATX.
AT/ATX mode select jumper settings are shown in Table 4-2 .