IEI Technology IVS-300-BT-J1/4G, Руководство пользователя

Страница: 90 / 110

IVS-300 Embedded System
Page 76
Figure 5-1: SO-DIMM Locations
Step 3: Remove the SO-DIMM by releasing the arms on the SO-DIMM socket.
Step 4: Align the new SO-DIMM with the socket. The SO-DIMM must be oriented in
such a way that the notch in the middle of the SO-DIMM must be aligned with
the plastic bridge in the socket ( Figure 5-2 ).
Step 5: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle
( Figure 5-2 ).
Figure 5-2: SO-DIMM Installation
Step 6: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down (See Figure 5-2 ).
Step 7: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket. Step 0: