IEI Technology ITG-100-AL, Руководство пользователя

Страница: 29 / 107

ITG-100-AL Embedded System
Page 17
Figure 3-3: Install the HDD
Step 4: Secure the HDD bracket with the system by the three retention screws that were
previously removed.
Step 5: Reinstall the bottom panel to the system.
3.4 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the ITG-100-AL. Please make sure the purchased SO-DIMM complies
with the memory specifications of the ITG-100-AL.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
Step 1: Remove the bottom panel by removing the two retention screws from the bottom
panel ( Figure 3-1 ).
Step 2: Locate the SO-DIMM socket on the motherboard ( Figure 3-4 ).