IEI Technology IMBA-C2160-R10, Руководство пользователя

Страница: 72 / 173

IMBA-C2160 ATX Motherboard
Page 58
Step 3: Insert the DIMM . Once aligned, press down until the DIMM is properly seated.
Clip the two handles into place. See Figure 4-6 .
Step 4: Removing a DIMM . To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket. Step 0:
4.3 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1 .
Description Label Type
AT/ATX power select JATX_AT1 2-pin header
Clear CMOS jumper J_CMOS1 3-pin header
Flash descriptor security override J_FLASH1 3-pin header
USB power select jumpers K/M_USB1_PWR1,
CNUSB1_PWR1,
USB_PWR1,
USB_PWR2,
USB_PWR3
3-pin header
Wake-on LAN WOL_SEL1 3-pin header
Table 4-1: Jumpers