IEI Technology IMBA-690AM2, Руководство пользователя

Страница: 119 / 256

IMBA-690AM2 Motherboard
Page 97
Step 1: Open the DIMM socket handles . The DIMM socket has two handles that
secure the DIMM into the socket. Before the DIMM can be inserted into the
socket, the handles must be opened. See Figure 5-4 .
Step 2: Align the DIMM with the socket . The DIMM must be oriented in such a way
that the notch in the middle of the DIMM must be aligned with the plastic bridge
in the socket. See Figure 5-4 .
Step 3: Insert the DIMM . Once properly aligned, the DIMM can be inserted into the
socket. As the DIMM is inserted, the white handles on the side of the socket will
close automatically and secure the DIMM to the socket. See Figure 5-4 .
Step 4: Removing a DIMM . To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket. Step 0:
5.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to close
an electrical circuit. It consists of two metal
pins and a small metal clip (often protected by
a plastic cover) that slides over the pins to
connect them. To CLOSE/SHORT a jumper
means connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means
removing the plastic clip from a jumper.
Before the IMBA-690AM2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the IMBA-690AM2 are listed in
Table 5-1 .
Jumper