IDDUPS-6364120A QIG IEI Technology Corp. Page 5
MONITORING DC POWER AND SMART
BATTERY
Follow the steps below to start the IDDUPS Battery Status Monitor
application.
Step 1:
Use the RS-232 cable to connect the JP2
connector on the IDDUPS series to the serial port
of the SBC.
Step 2:
Insert the application CD that comes with
IDDUPS series.
Step 3:
Double click the
IDDUPS.exe
icon (
Figure 5
).
Figure 5: IDDUPS Battery Status Monitor Application
Step 4:
A screen shown in
Figure 6
appears.
Figure 6: Status Information
IDDUPS Tabs
Descriptions
Status
Overview of the IDDUPS power module
Battery A
Lists Battery A information including type,
capacity, output voltage, temperature,
charging rate, discharging rate and
remaining time
Battery B
Lists Battery B information including type,
capacity, output voltage, temperature,
charging rate, discharging rate and
remaining time
Setting
Select custom COM port to communicate
with IDDUPS module. Enable or disable the
special event pop-up function.
About
License and development team
DANGER!
1. Disassemble and Reconstruction
“Do not disassemble or reconstruct battery”
The battery pack has safety function and
protection circuit to avoid the danger. If they have
serious damage, it will cause the generating heat,
smoke, rupture or flame.
2. Short-circuit
“Do not short-circuit battery”
Do not connect the + and – terminals with metals
(such as wire). Do not carry or store the battery
with metal objects (such as wire, necklace or
hairpins). If the battery is short-circuited, excessive
large current will flow and then the generating heat,
smoke, rupture of flame will occur. And also, it
causes generating heat at metals.
3. Incineration
and
Heating
“Do not incinerate or heat the battery”
These occur the melting of insulator, damage of
gas release vent or safety function, or ignition on
electrolyte. Above mentioned matters cause the
generating heat, smoke, rupture or flame.
4. Use
Nearby
Heated
Place
“Do not use or leave battery nearby the fire, stove
or heated place (more than 80
℃
)”
In case that separator made of polymer is melted
by high temperature, the internal short-circuit
occurs in individual cells and then it causes the
generating heat, smoke, rupture or flame. In
addition, do not use the battery under the heated
place (more than 80
℃
) for same reason.
5. Immersion
“Do not immerse the battery in water or sea water,
or get it wet”
If the protection circuit included in the battery is
broken, the battery will be charged at extreme
current or voltage and the abnormal chemical
reaction occurs in it. And then it causes the
generating heat, smoke, rupture or flame.
6. Charge Nearby Heated Place
“Do not charge battery nearby the fire or under the
blazing sun”
If the protection circuit to avoid the danger works
under high temperature or it is broken, the battery
will be charged at abnormal current (or voltage)
and abnormal chemical reaction will occur. It
caused the generating heat, smoke, rupture or
flame.
7. Charger and Charge Condition
“Do use the specified charger and observe
charging requirement”
If the battery is charged with unspecified condition
(under high temperature over the regulated value,
excessive high voltage or current over regulated
value, or remodeled charger), there are cases that
it will be overcharged or the abnormal chemical
reaction will occur in cells. It caused the generating
heat, smoke, rupture or flame.