IEI Technology HYPER-AL series, Руководство пользователя

Страница: 53 / 109

HYPER-AL SBC
Page 41
4.5 System Configuration
The system configuration is controlled by buttons, jumpers and switches. The system
configuration should be performed before installation.
4.5.1 AT/ATX Mode Select Switch
CN Label:
J_ATX_AT1
CN Type:
Switch
CN Location:
See Figure 4-4
CN Settings:
See Table 4-1
The AT/ATX mode select switch specifies the systems power mode as AT or ATX.
AT/ATX mode select switch settings are shown in Table 4-1 .
Setting Description
Short 1-2 ATX Mode (Default)
Short 2-3 AT Mode
Table 4-1: AT/ATX Mode Select Switch Settings
The location of the AT/ATX mode select switch is shown in Figure 4-4 below.
Figure 4-4: AT/ATX Mode Select Switch Location