GRAND-AL Series
Page 18
Step 7:
Align the notch on the gold edge of the riser card with the notch in the PCIe slot.
Insert the riser card module to the PCIe slot until it cannot go any further.
Step 8:
Fasten the screws. Close the case cover and fasten the screws.
Step 9:
Connect the power adaptor and cables to the GRAND-AL.
3.4.2 GRAND-AL-08B/12B Series
Step 1:
Turn off the GRAND-AL. Disconnect the power adaptor, network cable(s), and
any other connectors or cables from the GRAND-AL.
Step 2:
Before installing the expansion card, put on an antistatic wrist strap to prevent
electrostatic discharge. The crocodile clip should be connected to the ground.
Содержание GRAND-AL 08B Series
