IEI Technology F10B-BT, Руководство пользователя

Страница: 53 / 132

PPC-F08B/F10B-BT Panel PC
Page 39
Step 6: Once the flat panel PC with the attached rack/cabinet bracket has been properly
inserted into the rack or cabinet, secure the front of the rack/cabinet bracket to
the front of the rack or cabinet ( Figure 3-28 ). Step 0:
3.11.4 Arm Mounting
The PPC-F08B/F10B-BT is VESA (Video Electronics Standards Association) compliant
and can be mounted on an arm with a 75 mm or 100 mm interface pad. To mount the
PPC-F08B/F10B-BT on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 75 mm or 100 mm interface pad. If the mounting arm
is not VESA compliant, it cannot be used to support the
PPC-F08B/F10B-BT panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the
PPC-F08B/F10B-BT panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
PPC-F08B/F10B-BT panel PC. The arm mounting retention screw holes of the
PPC-F08B/F10B-BT panel PC are shown in Figure 1-3 and Figure 1-4 .
Step 4: Secure the PPC-F08B/F10B-BT to the interface pad by inserting four retention
screws through the mounting arm interface pad and into the
PPC-F08B/F10B-BT panel PC.
Step 0: