IEI Technology ECK-3692, Руководство пользователя

Страница: 135 / 170

ECK-3692G Embedded System
Page 119
Step 3:
Remove the old SO-DIMM from the socket.
Step 4:
Align the new SO-DIMM with the socket (
Figure 7-11
).
Figure 7-11: SO-DIMM Installation
Step 5:
Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle. (See
Figure 7-11
)
Step 6:
Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See
Figure 7-11
)
Step 7:
Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket.
Step 0:
7.4.5 Power Module Replacement
Power module replacement includes the following two procedures:
Step 1:
Removing the power module
Step 2:
Installing the replacement power module
Step 0:
7.4.5.1 Power Module Removal
To remove the power module, please follow the steps below.
Step 1:
Turn off the embedded system.
Step 2:
Disconnect the front panel power cable from the +12V socket or the terminal
block.