IEI Technology ECK-1000 Series, Руководство пользователя

Страница: 43 / 102

ECK-1000 Embedded System
Page 31
WARNING:
Do not wipe off (accidentally or otherwise) the pre-sprayed layer of
thermal paste on the bottom of the heat sink. The thermal paste
between the CPU and the heat sink is important for optimum heat
dissipation.
To install the included cooling kit, please follow the steps below.
Step 1: Place the cooling kit onto the CPU . Make sure the CPU cooling fan cable
can be properly routed when the cooling kit is installed.
Step 2: Properly align the cooling kit . Make sure its four spring screw fasteners can
pass through the pre-drilled holes on the PCB.
Step 3: Tighten the screws . Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.
Step 4: Connect the fan cable . Connect the cooling kit fan cable to the fan connector
on the motherboard. Carefully route the cable and avoid heat generating chips
and fan blades. See Figure 4-8 . Step 0:
Figure 4-8: Connect the cooling fan cable