3
For BRICK-KINO Series
Step 2:
Install a KINO SBC.
Align the
screw holes on the SBC with the
standoffs on the bottom panel. Secure
the SBC with four screws (round head,
M3*6). Connect the other end of the
SATA cable to the SATA connector and
the SATA power connector on the SBC.
For BRICK-NANO/WAFER Series
Step 2:
Install a NANO/WAFER SBC.
Align the screw holes on the SBC with
the standoffs on the bottom panel.
Secure the SBC with four screws (round
head, M3*6).
Step 3:
Assemble two edge bars
. Orient the bottom panel, and note the direction
of the corner notches as shown below. Align the slot of the edge bar with the edge of
the bottom panel, and assemble the edge bar to the side of the bottom panel. The
corner notches should still be visible after assembling the edge bars; if you install
them wrongly, the corner notches would be covered by the edge bars.