IEI Technology AFL2-W15A-N270, Руководство пользователя

Страница: 43 / 141

AFL2-W15A-N270 Panel PC
Page 31
Figure 2-19: Cutout
Step 3:
Slide the flat panel PC through the hole until the aluminum frame is flush against
the panel.
Step 4:
Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5:
Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (
Figure 2-20
).
Step 6:
Insert the panel mounting clamps into the pre-formed holes along the two edges
of the panel mounting brackets (
Figure 2-20
). There are a total of 4 panel
mounting clamps for the AFL2-W15A-N270.
Step 7:
Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
(
Figure 2-20
).