IEI Technology AFL-9652 Series, Руководство пользователя

Страница: 50 / 199

Page 32
Step 3:
Insert a CF card into the slot (
Figure 4-3
).
Figure 4-3: CF Card Installation
Step 4:
Replace the plastic back cover and fasten the retention screws.
Step 0:
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
4.6 HDD Installation
To install the hard drive, please follow the steps below:
Step 1:
Disconnect the system power cable.
Step 2:
Remove the plastic back cover. See
Section 4.5
above.
Step 3:
Remove the 10 round head retention screws and two flat head retention screws
securing the internal aluminum cover (
Figure 4-4
).