IEI Technology AFL-08AH-N270-CR, Руководство пользователя

Страница: 40 / 115

AFL-08AH-N270-CR Panel PC
Page 26
4.6.2 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type: 3-pin header
Jumper Settings:
See
Table 4-1
If the AFL-08AH-N270-CR fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
Table 4-1
.
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 4-1: Clear CMOS Jumper Settings
4.7 Mounting the System
WARNING!
When mounting the flat panel PC onto an arm, onto the wall or onto a
panel, it is better to have more than one person to help with the installation
to make sure the panel PC does not fall down and get damaged.