IEI Technology AFL-057A-Z510, Руководство пользователя

Страница: 48 / 122

AFL-057A-Z510/Z530 Panel PC
Page 37
Step 2:
Remove the motherboard retention screws holding down the motherboard
(
Figure 4-1
).
Figure 4-1: Motherboard Retention Screws
Step 3:
Push the external interface connector apart from the aluminum cover and lift the
aluminum cover off the AFL-057A-Z510/Z530.
Step 4:
Locate the DDR2 memory module on the motherboard of the flat panel PC
Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5:
Grasp the DDR2 memory module by the edges and carefully pull it out of the
socket.
Step 6:
Install the new DDR2 memory module by pushing it into the socket at an angle
(
Figure 4-2
).
Step 7:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR2 memory module down (
Figure 4-2
).
Step 8:
Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR2 memory module in the socket.
Step 0: