IEI Technology 232iLM, Инструкции по установке и программированию

Страница: 2 / 12

Keypad Installation Procedure:
Step 1: Drill through the back plate using a
11
/
64
” bit. Use the template on the back page to accurately mark the mounting
holes before drilling. Then drill the mounting holes with a
9
/
64
” drill bit. Also drill the hole for the wires. This may
vary depending on the number of conductors required.
Step 2: On the keypad end, strip back the insulator from the wire and tape the drain wire (shield) to the jacket. Now
connect the required wires to the 8-conductor wire harness provided. The wire harness plugs into the 8-position
connector on the keypad. At the other end of your wire run, strip back the insulator from the wire but
do not tape
the drain wire to the jacket. The drain wire must be connected to ground at the controller end. See the diagrams
below.
Step 3: Finally mount the SSWiLM keypad onto the mounting surface using the provided screws. Do no over-tighten the
screws, which may result in damage.
Wiring the SSWiLM to an IEI 232 Access Control Module
The connection between the SSWiLM and the 232 Controller requires a 4-conductor, stranded wire with overall foil shield.
The 8-conductor wire harness from the keypad connects to connector P6 on the controller. Connect the wires, color to
color (red to red, black to black, white/black to white/black and white/yellow to white/yellow). Refer to the wire lengths on
the first page. As mentioned above, the drain wire must be attached to Ground on the controller side, which is the V-
terminal or negative of your power supply.
Document # 6050800 Rev 1.1 2 of 12 www.ieib.com