12
六.
離合器調整 Clutch Adjustment
1.
當離合器握把放鬆時
,
使張力輪往上壓皮帶下方使皮帶壓緊產生傳動作用
,
如
圖示
A-3
引擎皮帶兩端皮帶呈平行狀態為最適當
When release the clutch lever , make the tension pulley turn upward to press the
bottom of the belt and then belt become tightly to produce transmission action .
As the Figure (A-3). The up and down of the belt should be parallel.
2.
當離合器握把壓緊時張力輪往下產生離的作用使傳動皮帶微接觸於皮帶調整滑
片上
,
如圖
A-4
所示 (離合握把放鬆須加壓握把
,
按下安全扣離合握把即可放
鬆)
When press or push the clutch handle, the tension pulley moves downward. And
then the belt is touch with the belt fastener lightly. As the Figure (A-4) (press the
clutch lever and push down the protector; the clutch lever can be released.)
3.
離合器導索之間隙必須預留約
8 ~ 15mm
避免張力輪無法壓緊皮帶產生皮帶打滑
磨損
,
如圖
A-3
所示
Keep 8 ~ 15mm gap for leading rope of the clutch wire to avoid the tension pulley
from unable tighten the belt and then sliding and wear away. As the Figure (A-3)
