Instruction Manual
Innovative DisplayWorks
G-Baby
SAFETY PRECAUTIONS
When using this appliance, always follow the basic safety precautions:
1. Read the entire Userʼs Manual before operating this appliance.
2. Use this appliance only for its intended purpose as described in this Userʼs Manual.
3. This cooler must be properly installed in accordance with the installation instructions before being used. See grounding
instructions on page 6.
4. Never unplug your cooler by pulling on the power cord. Always grasp the plug fi rmly and pull it straight out from the
outlet.
5. Unplug your cooler before cleaning or making any repairs. (Note: If for any reason this product requires service, we
strongly recommend that a certifi ed technician perform the service.)
6. Immediately repair or replace all electrical cords that have become frayed or otherwise damaged. Do not use a cord that
shows cracks or abrasion damage along its length, the plug or the connector end.
7. This cooler should not be recessed or built into an enclosed cabinet. It is designed for freestanding installation only.
8. Do not operate or store your cooler near or around explosive fumes, gasoline or other fl ammable vapors and liquids.
9. Setting the temperature control to the 0 position does not remove power to the light circuit, perimeter heaters, or
evaporator fans.
Please save these instructions!
DANGER!
Proper Disposal of the Refrigerator
To prevent any risk of child entrapment when discarding your cooler remove the doors and leave the shelves in place so that
children cannot easily climb inside.
PRE-CAUTION, NON-OPERATING COOLERS SHOULD HAVE:
1. Glass door removed.
2. Shelves kept in place in order to prevent any small child from climbing inside cooler.
FOR PROPER DISPOSAL OF COOLER:
Distributors / retailers need to contact a qualifi ed service technician:
1. To recover all Freon/refrigerant from the cooler
2. To remove the compressor or remove the oil from the compressor
Then the distributor/ retailer can contact their local metal recycling center to pick up the remaining cabinet, shelves, etc. By law,
disposal of hazardous wastes may be subject to fi nes and imprisonment under the provisions of the environmental regulations.
For more information please visit: http://www.epa.gov/osw/hazard/index.htm
PARTS AND IDENTIFICATION
3
2
1. Cooler Cabinet
2. Screw (4)
3. Leveling Leg (4)
4. Lockpin
5. Evaporator Bracket
6. Drainage Hose Elbow
7. Inner Drip Pan
8. Evaporator
9. Inner Fan
10. Fixation of Inner Fan
11. Fan Cover Grid
12. Shelf
13. Gasket
14. Top Hinge
15. Wire Clip
16. Glass Door
17. Bottom Hinge Washer
18. Bottom Hinge
19. Left Holder of Light Cover
20. Light Cover
21. LED Light (2)
22. Right Holder of Light Box
23. Transformer
24. Transforer Box
25. Left Cover of Light Box
26. Fixation Board of Light
27. Top Adornment Assembly of Light Box
28. Front Plate of Light Box
29. Bottom Adornment Assembly of Light Box
30. Left Cover of Light Box
31. Cabinet Cover
32. Compressor
33. Junction Box
34. Plastic Clip
35. Thermostat Box Cover
36. Thermostat
37. Thermostat Box
38. Switch
39. Thermostat Level Label
40. Compartment Grill
41. Power Cord
42. Drier
43. Drier Clip
44. Drier Bracket
45. Condenser
46. Condenser Clip
47. Connection Pipe
48. Outer Drip Pan
