Instruction Manual
Innovative DisplayWorks, Inc.
G-77/G-80/G-80L
10
11
MAINTENANCE
Cleaning
• Before cleaning the appliance, always
remember to unplug it.
• Unplug the cooler at the electrical outlet;
never pull the service cord.
• Do not use sharp or pointed objects for
cleaning.
• Clean the inside cabinet of the cooler with
a clean damp cloth. Avoid damage by
using non-abrasive and non-fl ammable
cleaning products.
• Clean the condenser at least once a
month with a vacuum cleaner or a brush to
eliminate the dust accumulation.
Power Failure
• Please minimize the frequency of opening
the door during a power failure.
• If your cooler is unused for an extended
period of time, unplug, empty, and clean
your cooler and keep the door open to
avoid condensation, formation of mold, or
odors.
Moving The Cooler
• Empty the unit.
• Secure all loose parts inside the cooler.
• Tape the door shut.
• During transportation, make sure that the
cooler is in an upright position.
Drip Pan
• During normal compressor cycle, water will
drain into the drain pan and evaporate.
• To clean, gently pull the drain pan towards
you and remove. Slowly reinstall it after
cleaning.
MAINTENANCE Accessing Cooler Components:
1. Remove the basket from
the inside of the cooler.
2. Remove the baffl er from
the base of cooler.
6. To re-assemble the
cooler, align the notch at
base with the cord. Then
reverse steps 1-5.
5. Lay the body of the
cooler on its side to
access components.
4. The body of the cooler
can now be worked free
from the frame.
3. Using a Phillips
screwdriver, unscrew the
(4) screws at the base of
the cooler.
LEVELING
• Place unit in a well ventilated area.
• WARNING: Warranty is void if ventilation is insuffi cient.
• Unit must be leveled for proper operation, this will help prevent condensation.
• The cooler should be leveled front to back and side to side with a level.
INSTALLATION AND OPERATION
• Connect the power source. After 30 minutes of operation, the unit should show signs of
cooling.
• After the empty cooler has been operating for a period of 5 hours, the unit can be loaded
with product.
BEVERAGE STORAGE
• Leave adequate space between beverage cans to allow air
circulation
• This cooler is primarily for storing beverage cans and plastic
bottles. Avoid putting glass containers in this cooler.
• All beverage products should be properly sealed to avoid
leaking into the cooler.
CLAMP INSTALLATION
1. The clamp secures the
lid assembly to the main
body of the cabinet.
Locate the (2) notches on
the interior of the lid.
2. Snap the (2) bolts into the
notches of the lid.
4. Hook the (2) clamps onto the
center bar of the basket.
3. Snap the (2) bolts into the
notches of the lid.
G-77 & G-80 Only
