Instruction Manual
Innovative DisplayWorks, Inc.
G-7f/GCG-7f
10
11
SETTING UP SPACERS & POWER CORD HOLDERS
These coolers are supplied with one set (2 pieces) of Spacers to hold the extra length of Power Cord.
START-UP, OPERATION AND TEMPERATURE ADJUSTMENT
Operation
Prior to stocking cooler with product, it should be operated empty for half an hour.
Temperature Adjustment
Switch Operation for Lit Door Logo
Button for Changing Motion Logo Modes
1
Take out the two Spacers
and Screws supplied in the
Accessory Pack shipped with
the Cooler.
Performance tested position of
the thermostat is between 4-6.
For GCG coolers only. The light switch
located at the bottom left hand side,
on the rear of the cabinet, is the ON/
OFF switch for the Lit logo located on
the door of cooler.
2
Use a Phillips screwdriver to
secure the two Spacers onto
the rear of the cooler.
Mode 1
: The logo lights are permanently lit and do not
sequence.
Mode 2
: The logo lights sequence showing the bottle
emptying and fl ashing full. This is the default setting.
Please Note:
When replacing the controller, remove four (4)
screws on the rear cover plate to gain access.
For These Models Only: GCG-7-FA934B, GCG-7-FA934B-HC
MAINTENANCE
Cleaning
• Before cleaning the appliance, always
remember to unplug it.
• Unplug the cooler at the electrical outlet;
never pull the service cord.
• Do not use sharp or pointed objects for
cleaning.
• Clean the inside cabinet of the cooler with
a clean damp cloth. Avoid damage by
using non-abrasive and non-fl ammable
cleaning products.
• Clean the condenser at least once a
month with a vacuum cleaner or a brush to
eliminate the dust accumulation.
Light Replacement
• Unplug the cooler before removing the
LED light strip.
• Remove the screws.
• Remove the light cover gently.
• Take out the LED light strip.
• Replace the used strip with new equivalent
light strip.
• Install the light cover and tighten the
screws.
• Plug in the cooler.
Power Failure
• Please minimize the frequency of opening
the door during a power failure.
• If your cooler is unused for an extended
period of time, unplug, empty, and clean
your cooler and keep the door open to
avoid condensation, formation of mold, or
odors.
Moving The Cooler
• Empty the unit.
• Secure all loose parts inside the cooler.
• Tape the door shut.
• During transportation, make sure that the
cooler is in an upright position.
Drip Pan
• During normal compressor cycle, water will
drain into the drain pan and evaporate.
• To clean, gently pull the drain pan towards
you and remove. Slowly reinstall it after
cleaning.