Innovative DisplayWorks
G-11c/GCG-11c
Instruction Manual
CONDENSER MAINTENANCE
It is essential to keep the condenser coils clean and free of dust and debris at all times. It is required to
periodically clean the condenser coils with a soft bristle brush or vacuum-cleaner to properly
maintain the refrigeration system. Failure to clean the condenser at regular intervals may
cause failure of the refrigeration system and could void the warranty.
1
Remove the rubber cap from the front grill.
2
Using a small Phillips head screwdriver, remove the three screws as
shown.
3
The front plastic grill can now be removed by pulling it up.
4
Using plastic bristle brush, carefully clean the coil being aware that coils can
bend or be damaged if too much force is used - shown left.
5
Replace grill and utilize the Phillips screwdriver to tighten the screws into place,
replace the rubber caps.
CANOPY GRAPHICS REPLACEMENT
1
Unscrew the Graphics Holder on the Left Hand Side of the Top Canopy
2
Carefully slide out the entire Graphics piece.
3
Replace with a new Graphics piece.
4
Carefully insert and slide in the new Graphics piece.
5
Fix the Graphics Holder by fastening the screw.
SETTING UP SPACER & POWER CORD HOLDERS
The G-11c/GCG-11c is supplied with one set (2 pieces) of Spacers to hold
the extra length of Power Cord (shown in picture below)
1
Take out the two Spacers and screws supplied in the
Accessory Pack shipped with the Cooler.
2
Use a Philips screw driver to fix the two Spacers at
positions as shown in picture below.
12
11
MAINTENANCE
Cleaning
• Unplug the cooler before cleaning.
• Use a soft cloth or sponge with water or soap (non-corrosive mild detergent). After cleaning, wipe the cooler using a
dry cloth to prevent the cooler from rusting.
• Do not spray water on the cooler, and do not use hard or steel brushes to clean the cooler.
• Do not use organic solvents, boiling water, washing powders or acids while cleaning.
• A drain or waste outlet may be provided for the draining of a display refrigerator. If the display refrigerator drains are
provided for fl ushing, they shall have a minimum internal diameter of 1˝ (25mm).
If the cooler will be in a non-operational state for a long period of time, clean as
instructed above, and keep the door open until interior is dry.
