ID TECH Kiosk V User Manual
Page | 16
Note:
The Kiosk V is post-compatible with Kiosk III and Kiosk IV dimensions. Posts are 36mm
apart in the lengthwise direction and 32mm apart widthwise. See drawing below.
Use the following instructions to mount the Kiosk V on the exterior of a kiosk structure:
1.
Using the Drill Template below, locate and mark the (4) 3.5mm (0.138 inch) mounting holes.
Note:
Verify the orientation of the Kiosk V before marking and drilling the holes. The
rectangle
hole
should be located towards the bottom of the mounting location to ensure that the Kiosk V is
oriented correctly with the LEDs at the top.
2.
Using the Drill Template, locate and mark the 9.95mm*15.77mm(0.392inch*0.621inch)
rectangle hole (used for connecting the USB-typ
e
C cable to the Kiosk V).
3.
Align the four M3 screws with the mounting holes and attach the Kiosk V to the outside
surface.
4.
Use the four screws to secure the Kiosk V to the outside surface of the kiosk. Make sure to
tighten the screws securely so that the Kiosk V does not move on the outside surface of the
kiosk.
5.
Route the end of the USB-Type C cable through the rectangle hole into the kiosk and tighten
the two M2 screws in the over mode of the USB-Type C cable to ensure the cable is locked
reliably.
