Rx2 Receiver 700-617-02C
Deleting Remote Transmitters
A remote transmitter can be deleted individually if the remote transmitter is available if not see “Default by Channel” below.
1.
Press the program button for the desired relay twice.
2.
The Red MODE LED and the chosen Yellow RELAY LED will illuminate.
3.
Wait for the Red MODE LED to flash.
4.
Press and hold the remote transmitter button to be deleted from the chosen relay.
5.
When the Green STATUS LED illuminates for 3 seconds release the remote transmitter button as the remote was
successfully deleted.
6.
When the Red MODE LED begins to flash again the next remote maybe deleted by repeating step 4 & 5.
7.
To exit programming press the program button pressed in step 1 and the Green STATUS LED and Red MODE LED will
first alternate and then switch off, programming will be automatically exited and the Rx2 will be ready for operation.
Default by Channel
Channel 1 & 2 are defaulted separately.
1.
Press Program button for the desired relay three times.
2.
The Green STATUS LED, Red MODE LED and chosen Yellow RELAY LED will illuminate.
3.
Wait for the Red MODE LED and Green STATUS LED to start flashing together.
4.
Press and hold the program button for the chosen relay the Green STATUS LED and Red MODE LED will start flashing
alternately.
5.
Keep pressing the chosen relay program button until the Green STATUS LED and Red MODE LED stop flashing
alternately and switch off.
6.
Once complete the Green STATUS LED and the Red MODE LED will first alternate and then switch off, programming will
be automatically exited and the Rx2 will be ready for operation.
Relay Pulse/Toggle mode (Default Relay 1 & 2 = 1 sec pulse)
Each relay can be set to toggle or pulse. The pulse time can be set from 1 second to 10 seconds.
1.
Press the Program button for the desired relay four times.
2.
The Yellow RELAY LED will illuminate.
3.
The Green STATUS LED and the Red MODE LED will begin to pulse together.
To set a pulse time, count the number of pulses to set the number of seconds the relay is to remain on and press the
program button to save the pulse time.
4.
To set the relay to toggle allow the Green STATUS LED and Red MODE LED to pulse eleven times and automatically exit
programming.
5.
Once complete the Green STATUS LED and the Red MODE LED will first alternate and then switch off, programming will
be automatically exited and the Rx2 will be ready for operation.
Installation Tips
1.
Install antenna vertically.
2.
Keep the Rx2 away from other devices, approximately one metre, that receive or transmit radio frequencies, I.e.
Monitoring company radio, and other remote receivers, etc.
3.
Keep away from metal as this could reduce signal strength being received.
4.
Do not glue the housing to a surface using glue that would react negatively with plastic as this could warp the
housing making it difficult to remove / replace the cover or keep the cover on for protection.
5.
When mounting avoid the screws from touching the electronic circuit board.
