v
iro
S
hoes
Automatic shoe cover dispenser
HOW TO USE
1. Place the Automatic Shoe Cover Dispenser on the floor.
Press the unit firmly on the floor to ensure the skid proof pads stay
in place.
Note: If the unit is easy to move when using,
wipe both the floor and skid proof pads with a wet towel.
2. When the unit is turned on the indicator light will illuminate.
Press the foot switch for 1 second to activate.
Note: The indicator light will go off automatically after 1 minute and
enter power saving mode.
HOW TO USE IN 3 STEPS
1. Ensure the film is curled upwards before placing your heel between the shoe plates.
2. Slowly slide your foot down the unit.
Press the tip of your toe on the foot switch for 3 seconds.
Hold for a few seconds to seal. After the seal plates open back up
remove your foot.
Note: For best results, keep shoe in place for three seconds after the
heating element completes its cycle to enhance the wrapping quality
and tightness.
3. The unit will automatically clip the film and seal it.
If the film did not completely cut after the sealing clip opened, pull the film lightly to remove the excess.
Note: Before stepping into the foot switch, raise your heel more so that the shoe will fit more precisely.
1. Pull the top cover open.
2. Place the roll of film into the dedicated compartment.
Using the ends on the roll, align to the track until you hear a click.
Note: Make sure the film rolls over when rolling out (not under).
Do not throw away black knobs,
they are not included with replacement rolls.
3. Insert the roll of film over the spool.
Make sure the roll is securely placed on each side.
4. Pull the film through the shoe plates.
5. Press the foot switch to cut off excess film.
Hold for 3 seconds.
6. Check to make sure the film seal is facing up.
7. See video online for detailed instructions.
HOW TO INSTALL FILM ROLL
GB
Thank you for purchasing our product- Automotive Shoe Cover Dispenser
Please read these instructions prior to using this device for the first time.
Rotating rod
Cover
Shoe plate
Switch
(On/Off)
Charger imput
Indicator
Skid proof pad
Foot switch
Sealing
tab
1
2
3
4
5
6
4 - Instructions for Use
1
2
3
