22 IDS1600 USER MANUAL NO. 700-146-01D ISSUED NOV 2002 VER 2.17
IDS1600 USER MANUAL
the entry delay. Although not essential, it is recommended that the [#]
key be pressed before entering a user code as this clears any
unintended key entries.
Enter the premises through a designated entry/exit door. Enter-
ing via any other route will cause an alarm.
As soon as the entry/exit zone is violated i.e. the door has been
opened, the entry delay begins.
The keypad buzzer will sound for the duration of the entry period
to indicate that a valid user code is required.
If the
ARMED
indicator remains illuminated, an error was made
while entering the user code, press the [#] key and re-enter the
code.
Once the system disarms, the
ARMED
indicator will extinguish
and the keypad buzzer will stop sounding.
If no valid user code has been entered by the end of the entry
delay period, an alarm condition will be registered.
If the entry period is too short, have your installer change the
entry delay period.
If four incorrect user codes are entered consecutively, the keypad
will be non-responsive for 30 seconds.
NOTE
:
If a strobe (or flashing light) has been installed and an alarm condition
is registered the light will continue flashing after the siren has timed
out. Entering a valid
[USER CODE]
will cancel the strobe.
7.2 Disarming a Partition from a Master Keypad
Hold down
[
MODE
] + [
PARTITION NUMBER
] + [
] + [
USER CODE
]
1.
Hold down the [
MODE
] key on a master keypad until the keypad
buzzer sounds.
P A R T I T I O N :
M
R
A
E
L
B
U
O
R
T
2.
Enter the [
PARTITION NUMBER
] you wish to arm followed by the
