Mod: MDM/011/M4 Rev 2
IDS GeoRadar
User Guide
QGG/2020/002
Rev. 1.1
6
Care and Transport
In the present section general information about ROCKSPOT system maintenance are provided. All
maintenance operations need to be performed with the system stopped and disconnected from the power
source. Different behavior can lead to injuries due to mechanical or electrical hazards. Particular attention
must be taken in verifying the following (but not limited to):
➢
Check that SU bracket
’s
bearing and tilt nodes are well tightened.
➢
Check the metallic ties that hold both SU and CU are well fastened to the pole.
➢
Visually check that all the connectors, both on SU and CU are well fastened and intact.
➢
Visually check the integrity of all the cables and cable pins.
➢
Visually check the integrity of LockOut-TagOut device (metal bar) on POWER connector of the SU.
➢
Check that the Pointing camera protective glass on SU is clean and free from dust, ice and water drops.
➢
If optional pole is present, check that the lobe knob that joins upper and lower pole sections and the pole
to the base are well tightened.
➢
If optional Wi-Fi antenna is present, check the correct alignment and free Line of Sight.
Содержание RockSpot
