IDRO900ME User
’
s Manual
Company
Date
Version
IDRO Co., Ltd
2021-11-01
V1.11.01
11
Identification with Radio and Optical
FCC Information to User
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions:
(1) the device may not cause interference, and
(2) the device must accept any interference, including interference that may cause
undesired operation of this device.
Caution : Any changes or modifications in construction of this device which are not
expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
This device generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technical for help.
End Product Labeling
The module is labeled with its own FCC. If the FCC ID is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. In that case, the
final end product must be labeled in a visible area with the following: “Contains FCC ID:
XVY-IDRO900ME-M”
OEM Responsibilities to comply with FCC
The module has been certified for integration into products only by OEM integrators
under the following
condition:
- The antenna(s) must be installed such that a minimum separation distance of at least
20 cm is maintained between the radiator (antenna) and all persons at all times.
- The module is limited to installation in mobile or fixed applications.
- The transmitter module must not be co-located or operating in conjunction with any
other antenna or transmitter except in accordance with FCC multi-transmitter product
procedures.
- Separate approval will be required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna configurations
other than supplied antennas.
As long as the condition above is met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
In the event that these conditions cannot be met, then the FCC authorizations are no