idomus IDO COMPACT +, Руководство по установке, Страница: 5 / 42

5
SAFETY REQUIREMENT’S
EN - IMPORTANT!
- Before the installation/ dismantling works are started, fence the dangerous zones and zones, where the
outsiders may get to. Mark the working zone by the warn-ing sign “Forbidden access to outsiders”;
- Wear the protective helmet while executing installation/ dismantling works at height;
Use the scaffold means while working at height (constructional shelving with enclosures
protecting from falling). These means have to be inspected and tested; they have to satisfy
the EU requirements, and be certified;
- While working on the shifting scaffolds, it is necessary to fixate the wheels protecting from
spontaneous shift;
- The side protection of three parts has to be used in the small scaffolds and shifted work
platforms, when the mat is at 2,0 m and bigger height (1).
- Push the small scaffolds and shifted work platforms very slowly on the smooth, firm
surface free of obstacles.
- The wheels have to be reliably fastened and anchored by the brake lever (2).
- Avoid any impacts.
- Push only in the longitudinal or diagonal direction.
- Before shifting the scaffolds, protect the unprotected parts from falling.
- Do not jump on the mat.
- The bridge cannot be installed between the shifted work platforms and the building.
- It is forbidden to install the lifting mechanisms on the platforms.
- Lean the ladder only on safe points of support. Leave the ladder’s bearer at least 1 m
above the plane, to which people are going to climb.
- Protect the leaning ladder from slip, falling down, glissade and sinking, e.g. increase the
distance between the lower supports, adjust the ladder’s legs to the surface, on which they
are erected, use the hitching devices to fasten the top of the ladder.
- Protect the ladder by enclosures in the movement zone.
- The ladder’s legs must have protection against slip. The floors (surface) have to be smooth
and not slippery;
- Erect the leaning ladder safely keeping the correct angle of erection. It has to be:
- 65 – 75° when the leaning ladder has spokes,
- 60-70° when the leaning ladder has stairs.
- The goggles or face protection have to be
used to protect eyes during drilling works;
- The respirator has to be used to protect
airways;
- Use the work tools according to the
manufacturer’s instructions;
Use personal protection equipment while
working;
- Use ear-tabs to protect hearing when the
work tool emits more than 85 dBa;
- Keep the work place tidy, clean from
constructional waste and other items, which
may cause hazard.