NJR-T01UHD/NJR-R01UHD Command Guide
21
4.5.2 Basic setting
4.5.2.1 Setting input
@GDT / @SDT
No-signal input monitoring
Function
Getting
Setting
Format
@GDT, device, ch, port
@SDT, device, ch, port, time
Return value
@GDT, device, ch, port, time
@SDT, device, ch, port, time
Parameter
device: Model
“1” fixed
ch: Input channel
1 to 512 = Input channel 1 to Input channel 512
If a command is input from the RS-232C connector of NJR-T01UHD or from the
IP-NINJAR Configurator, “1” is set (fixed).
port: Input connector
“1” fixed
time: No-signal input monitoring
0 = OFF, 2000 to 15000 = 2 sec. to 15 sec. [Default] 10000 = 10 sec
Set this value by the 1000 ms. If you set a value other than 0 for the lower 3 digits,
these values will be rounded down.
(For example, if you set it to 2955, the monitoring time is set to 2000 ms.)
Example
@GDT,1,1,1
@GDT,1,1,1,6000
Getting the no-signal input monitoring of Channel 1
6000 ms. (6 seconds)
@SDT,1,1,1,6000
@SDT,1,1,1,6000
Setting the no-signal monitoring of Channel 1 to
6000 ms. (6 seconds)
Completed
Remarks
The NJR-R01UHD does not support this command.
