MSD-501/502/701/702 User
’s Guide
74
7.13.1 Registering/editing control command
Menu Top
→
PRESET COMMAND
→
COMMAND EDIT
Setting for Each command
Setting value [Table 7.11] Setting value of control command
You can create and edit up to 32 control commands.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
[Table 7.11] Setting value of control command
Item
Setting
Description
Range
COM
CEC
PORT
yes
yes
Select “COM” or “CEC”.
COM: Communication
command [Default]
CEC: HDMI CEC control
COM SIZE
yes
no
Set the number of bytes to be sent starting with
the first byte.
0BYTE to 30BYTE
[Default]: 0BYTE
DELAY
yes
yes
Set the waiting time of the control command.
Use this item for devices such as projectors that
requires time to cool down after powering off.
0ms to 999s999ms
[Default] 0ms
Communicati
on port
yes
no
Set the following communication ports to “OFF”
(not sending communication commands) or
“ON” (sending communication commands).
Those ports can be set separately, and
communication commands can be sent to
multiple communication ports at the same time.
・
RS:RS-232C
*5
・
OUT1B RS: RS-232C of OUT1B
・
OUT2B RS: RS-232C of OUT2B
・
LOOP BACK: Internal loop back
・
LAN1 to LAN8: LAN connection 1 to 8
*6
OFF [Default]
ON
COMMAND
INPUT MODE
yes
no
Set the input mode of send command data.
Select “ASCII” if “DATA” of “COMMAND”
consists of only 0A, 0D, and 20 to 7D of ASCII
codes. S
elect “HEX” if “DATA” of “COMMAND”
includes other codes.
ASCII [Default]
HEX
Send
command
data
yes
no
Set the command from the first byte according
to the number of bytes set in “COM SIEZE” (up
to 30 bytes).
0A, 0D, 20 to 7D in
ASCII,
00 to FF in hex
[Default]: 20 (space)
