HDC-UHD Series User Guide
77
9.9.3 RS-232C sending channel
You can set the destination(s) of the sending data in transmission mode.
【
See: 9.9.2 RS-232C operation mode
Menu
C75: IN2
C76: OUT2 only
C77: All outputs
C78: RS-232C
WEB menu RS-232C SETTINGS
→
HDBT CONNECTION
→
TRANSMIT ENABLE
→
→
RS-232C
→
HDBaseT IN2
→
HDBaseT OUT ( OUT2, ALL )
Setting value
[Table 9.41] RS-232C sending channel
Setting
Front
WEB browser
Enabling RS-232C sending
on
Check box ON
(RS-232C, HDBaseT IN2, HDBaseT OUT(OUT2, ALL))
Disabling RS-232C sending
[Default]
oFF
Check box OFF
(RS-232C, HDBaseT IN2, HDBaseT OUT(OUT2, ALL))
Select the connector(s) to be set from the following connectors:
①
HDBaseT input connector (IN2)
②
HDBaseT output connector (OUT2 only)
③
HDBaseT output connector (All outputs)
④
RS-232C connector
HDC-TH421UHD
①
②
③
HDBaseT
OUT2
HDBaseT
OUT3
HDBaseT
OUT4
HDBaseT
OUT5
HDBaseT
IN2
RS-232C
④
RS-232C
controller
Switch
[Fig. 9.15] Receiving channel
Note:
Received data is not sent to the connector that receives the data.