IDK FDX-S Series, Руководство пользователя

Страница: 59 / 117

FDX-S Series User Guide
59
10.4.6 HDBaseT output long reach mode
Menu Top
→
OUTPUT SETTINGS
→
HDBT LONG REACH MODE
Setting for ALL, OUT01 to OUTn
Setting value OFF : Long reach mode OFF Up to 328 ft. (100 m) [Default]
ON : Long reach mode ON Up to 492 ft. (150 m)
You can enable/disable long reach mode for HDBaseT output.
With long reach mode, up to 1080p (24 bit)/dot clock 148 MHz is supported when using with IDK’s HDBaseT
product. Select a supported output format.
【
10.3.1 Output resolution
】
【
See: 10.4.7 Deep Color output
】
10.4.7 Deep Color output
Menu Top
→
OUTPUT SETTINGS
→
DEEP COLOR
Setting for OUT01 to OUTn
Setting value 24Bit [Default], 30Bit, 36Bit
You can select the color depth of HDMI signal.
“30bit” and 36Bit”: If signals are input with “30Bit” or “36Bit” and a sink device supporting Deep Color is
connected, the signals are output at
“30Bit” or “36Bit”, respectively. Since the transmission clock of “30Bit”
and
“36Bit” are faster than that of “24Bit”, noise may occur if a poor-quality cable or long cable is connected.
In those cases, the noise may be removed by selecting
“24Bit”.
HDMI/DVI scan conversion output board and HDBaseT scan conversion output board support up to
“30Bit”
Deep Color.
10.4.8 Window transition effect
Menu Top
→
OUTPUT SETTINGS
→
VIDEO SWITCHING EFFECT
Setting for ALL, OUT01 to OUTn
Setting value ON [Default], OFF
You can select a window transition effect
(“FREEZE
→
FADE OUT-IN
”) for when the video inputs are
switched.
HDBaseT output only
Scan conversion output only