FDX-64 Users Guide
33
7.3.2 No-signal input monitoring time [INPUT SIGNAL CHECK]
Monitoring time for when the source device does not output video signals due to the changes of EDID or
turning on/off the FDX
Use this menu to set the monitoring time which is from when a source device stops outputting signals to when
the FDX requests the source device to output video signals.
[Fig. 7.3] Monitoring time
Using menu
INPUT SETTING → INPUT SIGNAL CHECK
For
Each input connector (IN1 to IN64, ALL)
Set value
OFF, 3Sec to 15Sec [Default]: 10Sec
Notes:
● If you use the power-saving function or dual monitor of the PC (source device), set this menu to “OFF”.
PCs may release or cancel those functions if they receive the request to output video signals.
● If the set time is shorter than the timing that the source device outputs video, the source device may not
output video signals because it sets the output signals repeatedly. In these cases, set the monitoring time
longer.
[Fig. 7.4] Repeating output signal setting
Channels that do not have an input slot board cannot be selected in this menu.
Changing EDID
Monitoring
time
ON
OFF
Monitoring
time
Monitoring
time
Video output timing of source device
Video signals
from source
device
FDX requests source device to output
video signals
Changing EDID
ON
OFF
FDX requests the source
device to output video signals
Monitoring time
Hot plug
ON
OFF
Video signals
from source
device
