Part 2 - Configuration
68
●
Panic Record: Displays event status based on current
Panic Record status.
●
Check Recording: Displays event status based on
System Monitoring settings. For more information,
refer to the Monitoring on page 33.
●
Disk Almost Full/Disk Full: If the storage device
is not in Recycle status, event status is displayed
when the amount of disk space specified under
System Monitoring is reached and when the disk
becomes 100% full. For more information, refer to the
Monitoring on page 33.
●
Fan Error: Event is indicated when the cooling fan
cannot reach a certain RPM or fails for longer than 50
seconds.
●
eSATA Disconnected: Event status is displayed when
an eSATA device is abruptly disconnected.
●
Disk Config Change: It will be highlighted when
the NVR reboots after the hard disk drive has been
replaced.
●
No Storage Found: It will be highlighted when no
recordable storage device has been found.
Storage
Indicates each disk's status.
Configure Disk Bad and Disk Temperature settings under
Setup > System > Monitoring.
