19
Cascading
1
Connect the
RJ-45 uplink ports
of system 1 and system 2 using a UTP cable.
2
Check the
RJ-45 uplink
port SPD LED's status and verify that a normal connection has been
established between the two products.
If the PoE switch is not connected to network connection at 1000Mbps, the network bandwidth
may not be enough, and the NVR may not record video normally.
Direc
tIP™ P
oE S
witch
Direc
tIP™ P
oE S
witch
Port Connection Warnings and Tips
Keep the UTP cable length to less than 100m (328 ft).
•
Only use category 5 or higher UTP cables with RJ-45 connectors to connect to the system. The
system's ports can automatically distinguish between MID and MDIX connectors, so there is no
need to use a crossover cable when connecting to a different device's TX port.
•
The system's RJ-45 uplink ports may be used as service ports, but they do not support PoE.
[RJ-45 Port Connection]
