5
Network Camera
5
Audio In
6
Alarm In
7
Alarm out
Camera Installation
Inserting a SD Memory Card
1
Loosen the screws counterclockwise using the
allen wrench provided with the product.
•
Do not remove the screws from the top
cover, otherwise, they may hurt you
when they fall off.
•
Do not remove the safety wire from the
top cover and camera body. It prevents
the top cover from falling on to the floor
when detached from the camera.
2
Remove the top cover.
3
Insert a SD memory card into the SD memory card
slot with the ‘micro SD’ print facing upward.
microSD
•
Push the SD memory card until it
disengages from the slot, and then pull
it out.
•
microSD Logo is a trademark of SD-3C,
LLC.
Installation
•
Check the wall or ceiling to see if it needs to
be reinforced. The camera may fall off if the
wall or ceiling is not strong enough to support
its weight.
•
Install the camera in a shaded area. If the
camera is installed in direct sunlight, it may be
affected adversely.
Use the provided guide pattern to check the
distance between the screw holes if necessary.
1
Remove the white paper of the provided insulator
and attach it to the wall or ceiling. This may reduce
noise which could occur when the camera is
installed on a metalic surface.
2
After you insert the SD memory card in the
camera, secure the body on a wall or ceiling using
the screws, bushings, and anchors that came with
the camera.
Do NOT use the bushings if you did not
attach the insulator to the wall or ceiling.
•
Make it sure that a safety wire is
connected to the top cover and camera
body. It prevents the top cover from
falling on to the floor when detached
from the camera.
•
Attach the enclosed desiccant in the
body to prevent moisture.
